leila/ November 30, 2018/ Auto & Motor

Top Tips on How to Replace A Windshield

After a simple chip or crack on the windshield, what is going to happen is that the chip or crack will keep growing and therefore make your windshield unattractive and dangerous. After you take your car for repair and to be fitted with a new windshield, you’ll find that it is expensive and for this reason, you should teach yourself how to replace the windshield. This article is going to provide you with more information about the best tips on how you can replace the windshield.

The first step to take is to remove the old damaged windshield from your vehicle. To remove the damaged windshield, remove the rubber trim and peel the gasket from the groove around the glass, and eventually remove the clips that are keeping the molding in place. The next thing is to separate the windshield glass from the pinch-weld using a razor to cut the urethane seal. To cut the urethane seal might be a challenge to you because it is very strong and adhesive. You should ensure that you get the urethane seal from inside so that not to break the glass and cause a mess. The next thing that should do is lift the windshield and you should note that it is a two-person job. When you have lifted the glass, place it carefully on the ground where you will put it on top of a towel. This will avoid the mess of shattered glass at the garage or where you have parked.

You should then prepare the pinch-weld for the new windshield by using sandpaper to remove rust from it, then followed by water and a brush to clean away any contaminants. The next step is for you to apply a layer of urethane primer to the black band that surrounds the windshield so that to prepare for the installation of the new windshield. To learn moreabout how to install the new windshield, check out Windshield Guru.

Give about 24 hours for urethane dry before you can start driving again. You should then install a window gasket starting from one end and press it into the groove around the entire perimeter of the windshield. One of the last steps is to replace the trim around the windshield after you have made sure that urethane has dried completely. If you follow the above steps, then you are going to replace your windshield within no time. If you’re interested in finding out more about the other best Do-It-Yourself windshield replacement tips, click here.

Share this Post